02-23-2015, 04:39 AM
Check which wire connects directly to the feedback resistor.
In the schem you linked to, it says black it ground, but it doesn't seem to indicate it on the photo of your amp's schematic.
In the schem you linked to, it says black it ground, but it doesn't seem to indicate it on the photo of your amp's schematic.
(02-22-2015, 05:36 PM)cthendrico Wrote: PLEASE HELP! So in my gv22 I replaced the factory speakers with 2 altec[b] lansing 417-8c's that are 8 olm. I started looking at the wiring and got confused and am afraid that the amp had been incorrectly wired. The schematic says that gv22 should have two 8 olm speakers wired in series for a 16 olm load.
My question is that the speaker wires hardwired to the amp are green and black. Which one is positive and which one is negative?????
also if I wanted to change the hardwire setup to a mono phone socket speaker out, which wire color (green or black) to the tip and sleeve terminals of the jack respectively? p.s. i still want to use the external speaker jack.
heres the schematic if that helps
http://www.freeinfosociety.com/electroni...php?id=743
Actually that schematic I sent is different then the one glued to my amplifier.