03-02-2015, 09:04 PM
Ok so what I did last night was feed the writes that were connected to the speakers (Green and black) and feed them back up through the chassis. The green wire was connected to the extension speaker Jack tip. I left one side of the Green to extension speaker tip and I connected the other end to the new Jack tip. The black was connected to the transformer. I left one side of the black connected to the transformer and I fed the other end up through the chassis and attached it to the new Jack sleeve. Does this sound right? I plugged a 16 ohm and everything worked and sounded fine. I am actually out of town so I can't take pictures.
In a somewhat related question it appears that the extension speaker Jack had some isolating rubber around it to isolate it from the chassis. Is that imperative?
In a somewhat related question it appears that the extension speaker Jack had some isolating rubber around it to isolate it from the chassis. Is that imperative?