That is very unfortunate! Sorry to hear about it.
On the bright side. I think it is likely that the transformer is still functional. you can fit it back into the A-frame and use some varnish or epoxy to hold it in place. the red wire can be extended using new wire and heat shrink, and you can solder the blue and brown wires directly to the pins of the power tubes.
its a bit of work, but worth it for sure. Lets us know if you need some specific guidance, i would be happy to go into detail.
Also, document your progress in this thread. These sorts of problems are not totally uncommon and your documentation could help others in your situation
On the bright side. I think it is likely that the transformer is still functional. you can fit it back into the A-frame and use some varnish or epoxy to hold it in place. the red wire can be extended using new wire and heat shrink, and you can solder the blue and brown wires directly to the pins of the power tubes.
its a bit of work, but worth it for sure. Lets us know if you need some specific guidance, i would be happy to go into detail.
Also, document your progress in this thread. These sorts of problems are not totally uncommon and your documentation could help others in your situation