05-24-2017, 06:14 PM
I see a small blue resistor highlighted by my pencil that doesn't look original. I noticed the board is a little bit chard on the resistor below it. I'm ready to remove the death capacitor and add mygrounded cordbut this one has a standby switch so I'm a little confused. My father was an electrician he was blind in one eye I did tons of soldering jobs for him at homeI can replace components and capacitors and resistors all day but I don't have a knowledge of the circuitry. I'm hoping I don't have to pull each piece and test it. is that how it's done?