05-14-2018, 04:10 PM
(05-10-2018, 05:30 PM)jjmt Wrote: OK. I had some free time this evening and decided to look into this further. As I mentioned above: shielding. What I found when I took the back panel off can be seen in the attached image. in particular, the shielding on the back panel extended to cover only about two thirds of the actual chassis.
I added aluminum tape to cover the entire area covering the chassis. When done, the radio signal coming out of the speaker was *almost* gone. I actually thought it was gone entirely, but with a little straining, I could still hear it. But anyway, pretty good.
Take a look at your amps and report back?
Great info, will check soon. Amps are currently at the techs for tune-up. I do know that alot of the Reverberocket 2s have a full enclosure chassis, so not sure the aluminum tape would add benefit. Worth a look though! Our tech says he thinks he has a trick that may work. Will report back