Reverberocket II GS-12R sounds, mods, reverb etc

[jjmt]

Well-.....

I had already ordered the regular caps when I saw your guys posts. unfortunately. I've had bad experiences with can caps- and I've heard bad experiences. and I got some F&T caps for cheap.

I probably would have ordered the cap if I could have just dropped it in- but somebody has already messed with the cap wiring so I'm gonna have to spend some time on it anyways.

On that note- the schematic pasted to the inside of my cabinet has had the bottom portion torn away.

I've found a few pictures of a schematic that looks like mine, but they are severely poor quality and I cant even really read the values on a lot of parts.

DOes anybody have a decent resolution of the 1966 GS-12R reverberocket ii.

It has the 7591 power tubes, 6u10, and 12ax7's.

Mine has a single 40uf cap on the board (instead of the 2x20uf thing I've seen on others)

You all think I should use some terminal strips to wire these up? I'd appreciate some help during this process- but I'll probably report back in a week.

Thanks for the advice, sorry I missed it- I gotta get my email notifications worked out.

I've been looking at this schematic:

http://www.kbapps.com/audio/schematics/t.../gs12r.php

Without seeing into your chassis, it's hard to suggest a layout plan for individual caps. In the R12R it's typical to zip-tie a couple caps off to the side and then run wires to resters mounted on the board. Need to have space on the board for that, however.