10-09-2014, 05:21 PM
Thanks, hangman, you're correct!
Question: Should I worry about replacing the power tube and filter cap wiring? The wire gauge for this V4 is thin, and solid core, compared to the last V4 I owned. I think, given the layout of the rear panel, that this current V4 is older than my previous one, and I'm not sure if Ampeg started using thicker gauge wire or a previous tech replaced all the wire.
The first pic below is the current amp I'm working on, the second picture is from the previous V4 I owned - which I suspect is newer than the current one.
![[Image: 20141009_163957_zpszyecp7qr.jpg]](http://i157.photobucket.com/albums/t54/Beedoola/20141009_163957_zpszyecp7qr.jpg)
![[Image: IMG_1447_zps63425320.jpg]](http://i157.photobucket.com/albums/t54/Beedoola/IMG_1447_zps63425320.jpg)
Question: Should I worry about replacing the power tube and filter cap wiring? The wire gauge for this V4 is thin, and solid core, compared to the last V4 I owned. I think, given the layout of the rear panel, that this current V4 is older than my previous one, and I'm not sure if Ampeg started using thicker gauge wire or a previous tech replaced all the wire.
The first pic below is the current amp I'm working on, the second picture is from the previous V4 I owned - which I suspect is newer than the current one.
![[Image: 20141009_163957_zpszyecp7qr.jpg]](http://s157.photobucket.com/user/Beedoola/media/20141009_163957_zpszyecp7qr.jpg.html)
![[Image: IMG_1447_zps63425320.jpg]](http://s157.photobucket.com/user/Beedoola/media/IMG_1447_zps63425320.jpg.html)