10-10-2014, 11:05 AM
good question. the answer depends on what you wanna do.
I always pull the flyback diodes out, because I see them blowing up more often than I see a output transformer from a v4 without flyback diodes blowing up. (in fact I've only seen the latter once, and it was from an amp that had the flyback diodes installed)
so if you remove the flyback diodes. it makes the question moot. there would only be one wire left.
if you leave the flyback diodes, then i would put the brown wires all to the capacitor.
I always pull the flyback diodes out, because I see them blowing up more often than I see a output transformer from a v4 without flyback diodes blowing up. (in fact I've only seen the latter once, and it was from an amp that had the flyback diodes installed)
so if you remove the flyback diodes. it makes the question moot. there would only be one wire left.
if you leave the flyback diodes, then i would put the brown wires all to the capacitor.